You will have to search for it. But there is a solution on trackball NOT selecting that I think will help you. It appears that you have the opposite issue (unless you have gotten moisture or liquid in the device). Under the trackball assembly (on the circuit board) there is a piece of film over the board (square and tilted so it looks like a diamond). Underneath is the actual contact that clicks and performs the "Enter function". It's very likely that yours has either bent or corroded in a fashion that it is stuck "in". find the instructions. Carefully peel the film back and clean the contact or bend it back out (It should resemble a round dinner plate upside down. If it's opposite and sticking up you have damage it by turning it inside out. Remove and pop the dent back out and replace). As I said there is a step by step with photos you should review but it's worth a shot.
Good Luck and report back!
E
|